iNFiNiT! Family Operation Manual
Revision D 16-7 Mix Effects
The speed of the effect gradually increases to
the set speed, then slows down gradually to
completion. Transition is executed within the
duration set in
Speed.
The effect starts and stops at the set speed, with
no acceleration or deceleration. Transition is
executed within the duration set in
Speed.
2XWSXW3HUFHQWDJH/HYHOV
The Output Percentage level of the video signal of each
buffer is controlled by a Percent slider. Output Percent-
age levels can be set from
0 to 100 inclusive.
•
0: Output Percentage level of the video signal is 0.
The image
cannot be seen.
•
100: Output Percentage level of the video signal is
100. Image appears completely opaque, and covers
any image that is behind it.
•
1 - 99: Image appears to be very transparent (1) to
almost completely opaque (
99). Other images set
behind these images can show through.
Cursor to the slider you want to adjust. There are three
ways to adjust a slider:
• Press
CLR. Enter a value between 0 and 100 using
the Address Keypad, then press
.
• Press
SHIFT CHAR ÌÍ as many times as it is nec-
essary to reach the desired Output Percentage level.
• Use the mouse to drag the Percent slider to the
desired Output Percentage level.
Ease: In/Out
Ease: None
To Next Page
Loading...