Chyron infinit! series - 3.6.16 3 rd Output (iNFiNiT! Only) (SET-UP); 3.6.16.1 Standard iNFiNiT! 3 rd Channel Behavior

CHYRON Corporation
Start-Up 3-42 Revision D
[ ] 3. Press SHIFT CHAR + Ì or Í to make the
middle line appear identical to the two outer
lines. As you make this adjustment, the
Prompt Line displays the Current Offset.
Figure 3-39. Aligned Frame Buffer Cel RAM Alignment
[ ] 4. When the lines appear identical, press S or
select
Save. The alignment with its Current
Offset is saved.
[ ] 5. Press
Q or select Quit to exit this menu, and
again to exit the Cursor Channel Alignment
menu.
• To reset the cursor to the original setting, press
R or
select
Reset.
 UG2XWSXWL1)L1L72QO\ 
6(783
 6WDQGDUGL1)L1L7 
UG&KDQQHO%HKDYLRU
The Third Channel Output option (§14.4) adds a separate
output so that the contents of the buffer assigned to
CHANNEL B can be viewed independently of the con-
tents of the buffer assigned to CHANNEL A. CHAN-
NEL B output is viewed on a separate monitor. Although
the buffer assigned to CHANNEL B may have a scanline
background (§10.5), the Third Channel Output does not
display the background. As a result, when using the
ALT