Chyron infinit! series - 18.4.7.6 Exiting the Options Window; 18.4.8 Copy and Paste

CHYRON Corporation
Font Create Utility 18-16 Revision D
To set the Sharpness Level:
• Enter a value in the
SHARPNESS LEVEL: field.
 ([LWLQJWKH2SWLRQV:LQGRZ
To exit the Options window and save changes:
• Press
CNTL.
If any default values have been changed in the Options
window, an
X will appear in the Options field for that
Font.
To exit the Options window without saving changes:
• Press
ESC.
 &RS\DQG3DVWH
When entering information in the Font Convert Setup
List, you may want to duplicate some of the rows, and
then change one or two parameters in each.
To copy information to the Paste buffer:
• Place cursor on the row to be copied, then
CNTL O.
The information contained in this row is copied to
the Paste buffer.
To copy the information to another row:
• Place the cursor on the line that you to which you
would like the Paste buffer information copied, then
press
CNTL A. The information is copied to this row.
• A partial row can be copied starting from the cursor
position on a line.
Repeat the above steps for as many rows as necessary.