CHYRON Corporation
Advanced Playback 9-8 Revision D
NOTE
Timed Roll calculations include
Pause commands, but do not execute
Speed commands!
To set a Roll duration:
[ ] 1. Press
T
.
[ ] 2. Enter the duration of the Roll in minutes and
seconds, up to
99:99, then press
.
*R7R*
The GoTo command jumps from a step in the Roll Con-
trol Buffer List to any other specified step in the list.
To enter a
GoTo command:
[ ] 1. Press
G.
[ ] 2. Enter a destination step number from
0 to 99,
then press
.
NOTE
If the destination step is earlier in the
list than the GoTo command, an
endless loop is created. To stop and
exit the Roll while this endless loop is
being executed:
• Press ESC.
6WDWXV$
When a Roll is executed, provides error check of mes-
sages and time computations of the nine Roll speeds.
Whether or not the
Status command is entered, the Roll
does not execute if there are errors in the Roll Control
Buffer List.
To Next Page
Loading...