Chyron infinit! series - 7.2.8 Erase to New Screen Color (CNTL B E Q); 7.2.9 Erase Transform (CNTL ALT T)

CHYRON Corporation
Formatting & Editing 7-4 Revision D
 (UDVHWR1HZ6FUHHQ&RORU 
&17/%(4
There may be times when you want to do your work
against a background other than black. The default color
of the screen can be changed. This is known as “erasing
the screen to a different color” (Also see (§10.5.7).
[ ] 1. Create a full screen solid (not gradated) color
scanline background.
[ ] 2. Press
E. This signals the system to erase the
screen to a new color.
[ ] 3. Press
CNTL or Q to exit Background mode.
NOTE
The screen color that results is NOT a
scanline background. It becomes the
default screen color. A background
color set in this manner cannot be
recorded or gradated.
To change the default screen color
back to clear (black), use one of the
following methods:
• Repeat the above procedure, and
erase to a black background.
• Press CNTL B; press R or select
Reset; then press CNTL.
After any erase, the cursor returns to the left edge of Row
0 (upper left corner). This is also known as the
HOME
position.
 (UDVH7UDQVIRUP&17/$/77
To erase a Transform image from the screen:
• Press
CNTL ALT T.