Chyron infinit! series - 17.4.1 Buf (Buffer); 17.4.2 Type (Effect Type)

CHYRON Corporation
Multiple Effects 17-8 Revision D
 %XI%XIIHU
Buf indicates the frame buffer that is assigned a particu-
lar effect. If activated when Multiple Effects is executed,
the effect assigned to that buffer is executed. Activating
Mix enables a two buffer Mix Effect to be executed. All
parameters pertaining to a buffer’s effect are set in the
same row as that buffer designation.
To make a buffer and its assigned effect, or
Mix available
when Multiple Effects is executed, it must be activated.
To activate a buffer or the
Mix field:
• Cursor to the desired buffer or
Mix field, then press

or
SPACE BAR to toggle the buffer or Mix field to
highlight it; or click on the field.
To deactivate a frame buffer or
Mix field:
• Cursor to the desired buffer or
Mix field, then press

or
SPACE BAR to toggle the buffer or Mix field to
remove the highlight; or click on the field.
 7\SH(IIHFW7\SH
Type indicates the Effect Type that is assigned to a par-
ticular buffer.
An Effect Type (§15.2) governs how an old image leaves
the screen and a new image enters the screen. The prop-
erties that are controlled by Effect Types are as follows:
• Either image (old and/or new) can move or remain
stationary during the transition with all Effect Types
except
Roll, Crawl, DDR and CMF. In these cases, a
new message does not replace an old message. The
messages themselves contain the movement.
• Where applicable, you can select which image will
display on top of the other during the transition (
Hide
and
Revl (Reveal)).