iNFiNiT! Family Operation Manual
Revision D 9-79 Advanced Playback
NOTE
You cannot enter a speed to trigger
the next line Slow Reveal until the
previous line has finished its Slow
Reveal.
7ZR3DUW6ORZ5HYHDO
To execute a Two Part Slow Reveal, it is first necessary
to record a Two Part Slow Reveal Message.
5HFRUGLQJ7ZR3DUW
6ORZ5HYHDO
[ ] 1. Set up a multi-row message as in Figure 9-20.
[ ] 2. Place the cursor on the first row of text that
you want to slow reveal. In Figure 9-20, this
would be Row 4.
This divides the message into two portions. All rows
above the cursor (including a background) display nor-
mally when the message is read. You control when the
rows from the cursor position and below are revealed.
[ ] 3. Enter an empty message ID number using the
Address Keypad.
[ ] 4. Press
CNTL RCD SLOW REVL.
To Next Page
Loading...