Chyron infinit! series - 17.4.5 Rev (Reverse); 17.4.6 Time Settings

CHYRON Corporation
Multiple Effects 17-20 Revision D
To set Ease:
[ ] 1. Place the cursor on the desired buffer or
Mix
row, in the Ease column.
[ ] 2. Press the
SPACE BAR or click to toggle
through the following choices:
In, Out, In/Out,
or
None.
Ease is not available to Cut and DDR.
 5HY5HYHUVH
Rev (§16.5.3) controls the direction of the transition. It
can be set to
Off or On. The default setting is Off.
To set
Rev:
[ ] 1. Place the cursor on the desired buffer or
Mix
row, in the Rev column.
[ ] 2. Press the
SPACE BAR or click to toggle
through the following choices:
Off or On.
Rev is not available to Dislv, Cut, Roll, Crwl, Fade, and
DDR.
 7LPH6HWWLQJV
The Start Point, End Point and Length of each effect can
be set in the
Start, End, and Len fields for Buffers 1, 2,
3, Mix and Xfrm (Transform). Maximum lengths that can
be set in Multiple Effects are as follows:
• Entire Multiple Effects execution (not including DDR
clip) -
9999 fields
• Effect length (wipe, push, etc.) -
300 fields
• Transform script length -
9999 fields
• DDR clip - limited by capacity of DDR storage device
• CMF - limited by capacity of SCSI Express drive