Chyron infinit! series - 11.2.1.2 Format

iNFiNiT! Family Operation Manual
Revision D 11-3 Clock & Timer Displays
Timer Up Timer Up counts up from 00:00:00, or from a time value
you enter using
Reset (§11.2.2.2). The default display for-
mat is whatever was last set in the
Format: field
(§11.2.1.2).
Timer Down Timer Down is a counts down to 0 from a value entered
using
Reset (§11.2.2.2).
• Place the cursor in the
Mode: field. Press the SPACE
BAR
or click on the field to toggle through the
choices. Press

or move the cursor out of the field.
 )RUPDW
Format: Specifies display format of Clock or Timer, i.e. -
hours, minutes, seconds, tenths of a second and hundredths
of a second. The maximum length of the display is:
HH:MM:SS.TH
...where HH specifies hours, MM specifies minutes, SS
specifies seconds,
T specifies tenths of a second, and H
specifies hundredths of a second.
NOTE
Even if the selected Clock or Timer
format does not display hundredths
of a second, the internal Clock/Timer
counts hundredths of a second, and
is accurate to 0.01 second.
To set Format:
• Place the cursor in the
Format: field. Press the
SPACE BAR, then press CLR. Type in one of the
formats listed below. Press

or move the cursor
out of the field.
HH:MM:SS.TH MM:SS.TH SS.TH HH:MM M:SS
HH:MM:SS.T MM:SS.T SS.T HH H:MM
HH:MM:SS MM:SS SS H:MM:SS H:MM:SS.TH