Chyron infinit! series - 17.7 Multiple Effects Time Line

iNFiNiT! Family Operation Manual
Revision D 17-33 Multiple Effects
• Place the cursor on the Script: field, then press
ERASE.
The above methods erase the Transform buffer and the
currently active buffer. The Transform Script remains
loaded, and the Transform Time Line is still displayed.
Using the following procedure, the Transform Time Line
is still displayed, but you must reload the Script re-exe-
cute it.
• Place the cursor on the
Script: field, then delete the
Script name from the field by pressing the
Back-
space
key. Move the cursor out of the Script: field.
Note that when the Multiple Effects main menu is exited,
the
Script: field, Transform buffer and Transform Time
Line are erased, but a Transform image can still remain
on screen. To erase this image:
• Re-enter the Multiple Effects main menu, then place
the cursor on the
Script: field, even if it is blank.
Press
ERASE or just move the cursor out of the field.
 0XOWLSOH(IIHFWV7LPH/LQH
The Multiple Effects Time Line displays information
regarding Start Points, End Points and lengths of the
effects that are set up in Buffers
1, 2, 3, Mix and Xfrm
(Transform). These values in fields are reflected in
Start,
End, and Len fields in the Multiple Effects window.
Maximum lengths that can be set in Multiple Effects are
as follows:
• Entire Multiple Effects execution (not including DDR
clip) -
9999 fields
• Effect length (wipe, push, etc.) -
300 fields
• Transform script length -
9999 fields
• DDR clip - limited by capacity of DDR storage device