iNFiNiT! Family Operation Manual
Revision D 14-41 Buffers & Channels
After any XFER or CNTL XFER operation, the active
buffer can change. To avoid accidentally typing into the
wrong buffer:
•Use the
CNTL CHNG function (§14.8) to specify the
new active buffer.
OR...
• Check the
BUFFER: field in the Message Compose
main menu to determine the active buffer. You can
also check the
CHAR: field on the Message Compose
main menu to see which characters are being tracked.
;)(5&17/;)(5DQG
6FDQOLQH%DFNJURXQG
When XFER or CNTL XFER is executed, the scanline
background (§10.5) that is on AIR is transferred to PRE-
VIEW, regardless of whether that background was built
behind the active buffer or not. For example:
[ ] 1. Assign buffer 1 to CHANNEL A, buffer 2 to
CHANNEL B, and buffer 3 to PREVIEW.
Refer to §16.7 or §17.5 for this procedure if
necessary.
[ ] 2. Enter text into buffer 1; create a red scanline
background while working in buffer 1.
Enter text into buffer 2; create a blue scanline
background while working in buffer 2.
Enter text into buffer 3; create a green scanline
background while working in buffer 3.
[ ] 3. Make the active buffer
1 A AIR. You should
see text from both buffers 1 and 2, and the red
background created while working in buffer 1.
[ ] 4. Press
CNTL XFER. This function swaps the
contents of CHANNEL B with the contents of
PREVIEW.
To Next Page
Loading...