Chyron infinit! series - 12.5 Saving;Recording Function Keys; 12.5.1 Save;Record;Exit Procedures

CHYRON Corporation
Function Keys 12-16 Revision D
[ ] 3. Press the SPACE BAR. The first step is
executed, and the results appear on the Edit
Monitor.
[ ] 4. Continue to press the
SPACE BAR each time
you want to display a new step.
As the Function Key executes, the current step number
and
Keystroke column entry are displayed on the Prompt
Line.
To exit Single Step mode:
• Press
ESC.
 6DYLQJ5HFRUGLQJ)XQFWLRQ.H\V
 6DYH5HFRUG([LW3URFHGXUHV
You may create Function Keys for immediate use without
recording them to disk - however all unsaved Function
Key information is lost each time the system is turned off
or Message Compose is exited.
To exit and save the Function Key Sequence:
• Press Ì to move the cursor into the
Step column,
then press
CNTL.
To set up another Function Key:
• Press
CNTL again, then the new Function Key.
To exit without saving changes:
• Press
Ì to move the cursor into the Step column,
then press
ESC.