Chyron infinit! series - 18.4.4 Edge Type

iNFiNiT! Family Operation Manual
Revision D 18-9 Font Create Utility
If a number above 2000 is entered, the Font Size defaults
to
2000. VALUE XXXX IS NOT BETWEEN 10 AND
2000: CHANGED TO YYYY
appears on the Prompt Line,
where
XXXX is the number that was entered; and YYYY is
either
10 or 2000.
NOTE
The ability to type a large size
character may depend on a number of
factors. If CHARACTER EXCEEDS
SCREEN SIZE appears on the prompt
line, and the character does not
display on the screen, try any or all of
the following. After each adjustment,
try again to type the character.
• Adjust the Safe Title Box to a
larger size (§7.3.1).
• Shift the cursor to a different
location.
• Shift the page (SHIFT PAGE +
ÌÍÎÏ (§7.8.4). You can also
shift the page using Page Shift
mode (§7.8.5).
If none of these methods work, it will
be necessary to reconvert the font
using a smaller Font Size.
 (GJH7\SH
Five Edge Types are available: NO EDGE; BORDER;
SHADOW; OFFSET; and CMBND. (Combined), which is
a combination of
SHADOW and BORDER.
To choose an Edge Type:
• While in the
EDGE TYPE field, then press the
SPACE BAR to toggle through the above choices.
Press

or cursor to the next field.
OR...