iNFiNiT! Family Operation Manual
Revision D 8-33 Directory Features
To display the offset message:
• Read the message that was recorded while the offset
was active.
&17/5($'
Any time you read a message, the system attempts to dis-
play the message using currently loaded Machine Fonts.
If the font isn't loaded, your page is not displayed cor-
rectly and
XXXX FONT FILE NOT FOUND appears on
the Prompt Line.
To read a message and load the fonts that were used to
create the message:
[ ] 1. Press
CLR, then enter the selected message ID
number using the Address Keypad.
[ ] 2. Press
CNTL READ.
Loading Font XXXX Into Position Y appears on the
Prompt Line as each font is loaded.
If the fonts are not available,
XXXX FONT FILE NOT
FOUND
(where XXXX is the Machine Font ID number)
is displayed on the Prompt Line, and the following win-
dow is displayed:
Figure 8-14. Cannot Load Font Warning
If fonts do not load during the CNTL READ operation,
access the Font List feature (described in §6.7) to con-
firm that the fonts are listed in the current directory.
WARNING - Press Y to continue.
CANNOT LOAD FONT XXXX
To Next Page
Loading...