Chyron infinit! series - 23.4.7 Cropping a Recorded CMF; 23.4.8 Video In (V)

iNFiNiT! Family Operation Manual
Revision D 23-25 Total Motion Control
If desired, the Crop Box can be recorded as a
Crop Box message:
• From within the CMF Crop window, press
CLR; enter an ID number, then press RCD.
The Crop message is stored in the current
Message Compose directory.
 &URSSLQJD5HFRUGHG&0)
A previously recorded CMF can be further cropped as
follows:
[ ] 1. Read the CMF.
[ ] 2. Reduce the Crop Box.
[ ] 3. Record the CMF without setting In or Out
Points, or Loop. See §23.4.14 for information
on recording a CMF.
NOTE
A recorded cropped CMF cannot be
“uncropped.” Increasing the size of a
Crop Box adds an opaque black
border to the CMF. If unsure of the
final size of a CMF, be sure to record a
copy of the largest version you think
might be used.
 9LGHR,Q9
Enabling Video In allows the system to accept video
from an outside source, be it a DDR, VTR, camera or
other device.
Video In must be enabled before execut-
ing a Capture.
To toggle Video In Enable/Disable:
• Press
V or select Video In. The Prompt Line reflects
the status that has been set.