Chyron infinit! series - 23.4.11 Editing the Clip - Mark In (I), Mark Out (O), Loop(L)

CHYRON Corporation
Total Motion Control 23-30 Revision D
NOTE
Scene cuts from simple to complex
video can cause system malfunction
during playback.
  (GLWLQJWKH &OLS 0DUN ,Q ,
0DUN 2X W2  /RRS /
After Capture, it may be desirable to trim the clip, or per-
haps loop it to allow it to play through more than once.
The In point, Out point, and Loop can be set before
recording as follows:
•
To set the In point: Using one of the methods
described above, stop the clip execution at the point
where you would like it to start. Press
I, select Mark
In
or right click. A vertical line appears on the Time
Line where the In point is marked.
Press
SHIFT ROW + Ì or Í to move the In point
backward or forward one frame respectively. Super
Shift also works.
•
To set the Out point: Using one of the methods
described above, stop the clip execution at the point
where you would like it to end. Press
O, select Mark
Out
or right click. A vertical line appears on the
Time Line where the Out point is marked.
Press
SHIFT PAGE + Ì or Í to move the Out point
backward or forward one frame respectively. Super
Shift also works.
NOTE
When both In and Out points have
been set, the area between the two
vertical lines on the Time Line is filled
in with gray.