CHYRON Corporation
Mix Effects 16-16 Revision D
[ ] 4. Set the Output Percentage level (§16.5.5) of
CHANNEL A to
100 and CHANNEL B to 0.
OR...
Set the Output Percentage level of CHANNEL
A to
0 and CHANNEL B to 100.
If both CHANNELS are set to 100%,
Both
channels cannot be set to 100 percent
appears on the Prompt Line.
To execute a Mix Effect:
[ ] 1. Set all parameters that apply to the particular
Effect Type and Transition Pattern.
[ ] 2. If necessary, press
ERASE DO to clear the
Read Next buffer (§16.9.2.1).
[ ] 3. While in the Mix window, press
CLR, then
enter the ID number of the first message using
the Address Keypad.
[ ] 4. Press
READ NEXT.
This loads the message into the Read Next
buffer.
XXXX Message read - Read next
buffer ready
appears on the Prompt Line,
where
XXXX designates the type of message
(e.g.
Full Page Message).
NOTE
You cannot perform READ NEXT
operations using Text & Graphics
messages.
[ ] 5. Press READ NEXT.
The first message appears on screen as set up
in Mix Effects. Additionally, the following
message is loaded into the Read Next buffer.
Whenever a Mix Effect is executed, the active
buffer becomes the buffer that has been
To Next Page
Loading...