CHYRON Corporation
Disk Utilities 19-44 Revision D
Add After entering the SCSI ID and LUN of the drive you are
adding, press
CNTL A or select Add to place the drive
you have defined into the configuration table.
If no drive is attached, or if the drive is not ON or up to
speed (or if, in removable types, the disk is not in the
drive) the error message:
You Must Insert a Disk in
Order to Configure a Drive
appears.
The system reads the drive to determine capacity in MB
(megabytes) and type (fixed or removable). The drive is
assigned the next open letter in ascending order, and
placed in the list.
Delete Removes a drive (unconfigures it) from the list. Use the
cursor keys to highlight a drive in the list. Press
to
select the drive and open the following field above the
SCSI ID: field.
Figure 19-29. Selected Drive Field
X is the selected drive (E, F, etc.). Press CNTL D or select
Delete to remove the drive from the list.
Modify Allows you to update the capacity and type of drive cur-
rently highlighted in the list. This is used when you
replace an existing drive. Use the cursor keys to highlight
a drive in the list. Press
to select the drive and open
the SELECTED DRIVE window described above.
Press
CNTL M or select Modify. The following window
appears:
Figure 19-30. X Already Configured Window
SELECTED DRIVE: X
X already configured.
Enter Y to continue.
To Next Page
Loading...