iNFiNiT! Family Operation Manual
Revision D 21-21 RGB Tools
Figure 21-12. Transparency Control Window
[ ] 2. Enter a value from 0 (completely transparent)
to
100 (completely opaque). The default value
is
100.
[ ] 3. Press
or click the right mouse button to set
the value in the slider.
Because the original image is kept in a non-
displaying buffer, and a copy is used for each
modification, no effect on image quality occurs
even after repeated alterations.
[ ] 4. Press
DO or X, or select Execute.
This erases the buffer, then a copy of the RGB
image is read from the non-displaying buffer to
the display buffer. The new Transparency is
then applied.
[ ] 5. Adjust Transparency as often as needed, then
press
Q or select Quit to close the
Transparency Control window and fix the
object at its new Transparency level.
• To exit the Transparency Control window
without applying any changes, press
ESC.
To Next Page
Loading...