iNFiNiT! Family Operation Manual
Revision D 2-39 Installation
Figure 2-18. Video Input Module (Option) Hookup
Hookup without an external Black Burst reference:
In the event that a facility reference signal (such as black burst)
is not available, the secondary configuration would be to utilize
the SYNC OUT signal from the back of the iNFiNiT! Family
system. Then, route this signal to the GENLOCK INPUT of the
outboard RGB video source.
NOTE
Certain component video sources might
have Sync information encoded on the
Green channel. If that is the case, be sure
to select VIM SYNC: GREEN on the Set-Up
menu of the Program Loader.
For instructions, refer to §3.6.4, Set Video
(SET-UP V), on page 3-15.
GEN LOCK
SYNC OUT
RED
GREEN
BLUE
KEY
EXT. SYNC
Outboard RGB Video Source Outputs
Red Green Blue Sync Key Blk/Burst
Facility Black/Burst
D.A. Output
DA
CHYRON Video Input Module
CHYRON Main Chassis
To Next Page
Loading...