Chyron infinit! series - Page 398

CHYRON Corporation
Advanced Playback 9-56 Revision D
CRAWL AREA TOO
LOW.
The cursor is positioned
too low on the screen.
OR...
The Font Size is too
large and cannot be
accommodated in the
Crawl area.
Move the cursor up to a
higher position on the
screen.
OR...
Change the Font Size.
NOT ENOUGH
ROWS IN CRAWL
BUFFER.
Not enough text rows
were recorded to fill the
multi-row Crawl buffer.
Reduce the number of
rows specified in the
Row command in the
Crawl Control Buffer
List.
CRAWL AREA TOO
LARGE.
Message cannot be
crawled when the Crawl
area exceeds 512 scan-
lines.
Move the cursor up to a
higher position on the
screen.
OR...
Change the Font Size.
Crawl Buffer
Underflow
This error can occur during Crawl execution at high
speeds. This indicates that the information to be
crawled is not being processed quickly enough to
follow the commands in the Crawl Buffer Execution
List
or the speed change commands from the key-
board. This causes the Crawl to pause during exe-
cution, until the information is processed. The
Crawl then resumes. Note that this does not make
up lost time in a Timed Crawl.
Crawl Buffer Underflow may also be the result
of trying to execute a Crawl using messages that
are stored on a floppy disk or other removable
media. These drives cannot supply data to the
CPU as quickly as the Hard Drive can.
Table 9-6: Crawl Control Buffer Error Messages
(UURU0HVVDJH ([SODQDWLRQ )L[