CHYRON Corporation
Advanced Read FX 15-20 Revision D
•Set Fonts: in the directory defaults to Y (§6.6.4).
The necessary fonts automatically load when the
message directory you are using becomes the current
directory.
To execute a Read Effect:
[ ] 1. Set all parameters that apply to the particular
Effect Type and Transition Pattern.
[ ] 2. If necessary, press
DO to clear the Read Next
buffer (§15.6.3).
[ ] 3. Press
CLR, then enter the ID number of the
first message.
[ ] 4. Press
READ NEXT.
This loads the message into the Read Next
buffer.
XXXX Message read - Read next
buffer ready
appears on the Prompt Line,
where
XXXX designates the type of message
(e.g.
Full Page).
NOTE
You cannot perform READ NEXT
operations using Text & Graphics
messages.
[ ] 5. Press READ NEXT.
The first message appears on screen as set up
in Read Effects. Additionally, the following
message is loaded into the Read Next buffer.
[ ] 6. Repeat Steps 2 and 3 however many times it is
necessary to display all of the messages in the
sequence. Press
READ NEXT twice to stop the
search at the last message in the sequence.
To Next Page
Loading...