CHYRON Corporation
Total Motion Control 23-12 Revision D
Control Buttons: Used to play back the captured video or a CMF for
viewing and editing. Playback in real time, by skip-
ping frames, or frame by frame.
Capture Type: Enables record of a CMF, JPEG Video, JPEG Key, or
JPEG Video plus Key.
Note: Requires CLYPS
Option JPEG hardware.
Function Icons:
These access Video In activation, capture, editing,
reading, recording, shaping and TMC configure.
They are listed in the table below in alphabetical
order.
Table 23-1: Total Motion Control Panel Function Icons
Function
Icon
Function
Capture (C) Performs capture of video in real time from outside source.
Configure (N) In this menu, set screen position of the captured video, Start Field,
Capture Limit, SCSI Express ID, and execute Capture File cre-
ation.
Crop (X) Set X and Y dimensions (size) of the Capture.
Help (?) Provides a list of Total Motion Control Panel keyboard shortcuts.
Mark In (I) Set Start frame of CMF animation that is to be recorded.
Mark Out (O) Set End frame of CMF animation that is to be recorded.
Quit (Q) Quit Total Motion Control Panel menu. Capture remains on screen
until erased from frame buffer.
Read (READ) Display CMF Read window, where CMF animation can be
selected for display.
Record (RCD) Display CMF Record window, where CMF animation can be
recorded to the selected SCSI Express drive.
Shaping (H) Multiplies RGB by Key.
Video In (V) Activates the Video Input Module. Video input is then captured
and stored as a Capture file. It can then be edited and recorded.
To Next Page
Loading...