CHYRON Corporation
Flash Font 13-8 Revision D
In this tutorial, a 50-scanline font with no edge will be
converted into an 80-scanline, offset edge font. Review
these basics for navigating the Flash Font menus:
Size:
Press F, TAB or SHIFT + TAB to move to the Font Size:
field. This field initially displays 50, which is the scanline size
of the letter the Edit Monitor cursor is “parked” on. Enter
80,
then press
; or click and hold the mouse on the
Size: up
arrow until the
Size: field displays 80.
As you change the size, watch the selected character on the
Edit Monitor (Figure 13-3) change in appearance.
Figure 13-3. Flash Font Size Change
Italic:
Press I, TAB or SHIFT + TAB to move to the Italic: field.
Enter 1 on the Address Keypad, then press SHIFT CHAR +
Í or Ì to set a positive or negative italic angle. Italics may
be entered in the range of
-20 to +20 degrees. As you
change the italic angle, the character on the Edit Monitor
reflects these changes. You may also click on the arrows
using the mouse!
Color Edit Monitor
ABCDE
To Next Page
Loading...