CHYRON Corporation
Message Compose Basics 6-20 Revision D
The following sample font listing (Figure 6-7) shows
how the parameters are specified in a list:
Figure 6-7. Sample Font Listing
NOTE
When working in Flash Font (Section
13) or the Font Create Utility (Section
18), Drop Shadow is called “Shadow”.
ID:
The numeric range is from 0 to 9999 inclusive. Use the
"
-" to list an inclusive range (example, 100-199). Use the
"
*" to list all fonts beginning or ending with, or contain-
ing a particular number. For example, entering
1* lists
all fonts with IDs beginning with "
1", whereas entering
*82 would list all fonts with IDs ending in "82", such as
1082, 2182, etc. Entering *2* lists font ID’s such as
0123, 0200, etc.
Name: The name can be alphabetical and/or numeric. In the
example above, list all Deco fonts by entering
Deco*.
Narrow it to a type of Deco by entering
Deco 901*. The
system searches for all fonts beginning with
Deco 901.
Entering
Broadway* would NOT list Deco Broadway
fonts.
The "
-" or "*" can also be used in the Name: field. To list
the Broadway fonts, for example, enter
*Broadway*.
0012 DECO 901 BROADWAY/HEAD (TM)
80 scanlines Drop Shadow 8 lines left
ID
SIZE
EDGE
NAME
To Next Page
Loading...