To Next Page

To Previous Page

one-way-hardware-timestamp;

probe-count count;

probe-interval seconds;

probe-type type;

routing-instance instance-name;

source-address address;

target (url url | address address);

test-interval interval;

thresholds thresholds;

traps traps;

}

NOTE: The ACX Series routers do not support the configuration of RPM

probes to a routing instance along with the configuration of the

hardware-timestamp statement.

NOTE: ACX5000 line of routers do not support hardware-timestamp feature

for RPM.

Documentation

Configuring Real-Time Performance Monitoring•

• Examples: Configuring Real-Time Performance Monitoring

• show services rpm probe-results

TWAMP on ACX Series

The Two-Way Active Measurement Protocol (TWAMP) defines a standard for measuring

IP performance between two devices in a network. You can configure TWAMP on ACX

Series routers. ACX Series routers support only the reflector side of TWAMP.

For more information about TWAMP, see RFC 5357, A Two-Way Active Measurement

Protocol (TWAMP).

To configure TWAMP properties, include the twamp statement at the [edit services rpm]

hierarchy level:

[edit services rpm]

twamp {

server {

authentication-mode mode;

client-list list-name {

[ address address ];

authentication none];

}

max-connection-duration hours;

maximum-connections count;

maximum-connections-per-client count;

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000