Juniper ACX2000 Configuration Guide

CHAPTER 9
Configuring Timing and Synchronization
•
Automatic Clock Selection Overview on page 224
•
Clock Sources on page 225
•
External Clock Synchronization Overview for ACX Series Routers on page 226
•
Configuring External Clock Synchronization for ACX Series Routers on page 228
•
IEEE 1588v2 PTP Boundary Clock Overview on page 234
•
IEEE 1588v2 Precision Timing Protocol (PTP) on page 237
•
PTP over Ethernet on ACX Series Routers Overview on page 238
•
Guidelines for Configuring PTP over Ethernet on page 240
•
Configuring Precision Time Protocol Clocking on page 243
•
Configuring a PTP Master Boundary Clock on page 244
•
Example: Configuring a PTP Boundary Clock on page 248
•
Example: Configuring a PTP Boundary Clock With Unicast Negotiation on page 250
•
Configuring a PTP Slave Clock on page 254
•
Example: Configuring an Ordinary Slave Clock With Unicast-Negotiation on page 257
•
Example: Configuring an Ordinary Slave Clock Without Unicast-Negotiation on page 261
•
Configuring Precision Time Protocol Over Integrated Routing and Bridging on page 264
•
Understanding Transparent Clocks in Precision Time Protocol on page 267
•
Configuring Transparent Clock Mode for Precision Time Protocol on page 269
•
Configuring a PTP Transparent Clock on page 270
•
Configuring PHY Timestamping on page 270
•
Configuring PHY Timestamping on ACX2200 Routers on page 273
•
G.703 2.048MHz Signal Type for BITS Interfaces Overview on page 274
•
Configuring PTP Multicast Master and Slave Ports for Ethernet Encapsulation on page 274
•
Configuring PTP Dynamic Ports for Ethernet Encapsulation on page 280
•
Example: Configuring PTP over Ethernet for Multicast Master, Slave, and Dynamic
Ports on page 281
•
Hybrid Mode on ACX Series Routers Overview on page 288
•
Guidelines for Configuring Hybrid Mode on ACX Series Routers on page 290
223Copyright © 2017, Juniper Networks, Inc.

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English