Juniper ACX2000

CHAPTER 8
Configuring CESoPSN Support on
Interfaces
•
Configuring CESoPSN Encapsulation on DS Interfaces on page 205
•
Configuring CESoPSN on Channelized OC3/STM1 (Multi-Rate) Circuit Emulation MIC
with SFP on page 206
•
Configuring CESoPSN Encapsulation on DS Interfaces on page 215
•
Configuring CE1 Channels Down to DS Interfaces on page 218
•
Configuring CESoPSN on Channelized E1/T1 Circuit Emulation MIC on page 220
Configuring CESoPSN Encapsulation on DS Interfaces
Circuit Emulation Service over Packet-Switched Network (CESoPSN) is an encapsulation
layer intended to carry NxDS0 services over a packet-switched network (PSN).
To configure CESoPSN encapsulation on a DS interface:
1. Create the DS interface.
[edit interfaces]
user@host# edit interface ds-fpc/pic/port:partition
For example:
[edit interfaces]
user@host# edit interface ds-0/0/1:1
2. Configure the encapsulation.
[edit interfaces ds-fpc/pic/port:partition]
user@host# set encapsulation cesopsn
3. Configure the logical interface.
[edit interfaces ds-fpc/pic/port:partition]
user@host# set unit logical-unit-number
For example:
[edit interfaces ds-0/0/1:1]
user@host# set unit 0
205Copyright © 2017, Juniper Networks, Inc.