vpi (Define Virtual Path)
Syntax vpi vpi-identifier {
maximum-vcs maximum-vcs;
oam-liveness {
up-count cells;
down-count cells;
}
oam-period (disable | seconds);
shaping {
(cbr rate | rtvbr peak rate sustained rate burst length | vbr peak rate sustained rate burst
length);
queue-length number;
}
}
Hierarchy Level [edit interfaces at-fpc/pic/port atm-options]
Release Information Statement introduced before Junos OS Release 7.4.
Description For ATM interfaces, configure the virtual path (VP).
NOTE: Certain options apply only to specific platforms.
Options vpi-identifier—ATM virtual path identifier. This is one of the VPIs that you define in the vci
statement. (For a list of hierarchy levels at which you can include the vci statement,
see vci.)
Range: 0 through 255
The remaining statements are explained separately. See CLI Explorer.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring the Maximum Number of ATM1 VCs on a VP
• multipoint-destination
• promiscuous-mode on page 1682
• vci on page 1773
1777Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
