show bgp replication
Syntax show bgp replication
Release Information Command introduced in Junos OS Release 8.5.
Command introduced in Junos OS Release 11.3 for the QFX Series.
Support for logical-system option introduced in Junos OS Release 13.3
Description Displays the status of BGP state replication between the master and backup Routing
Engines on devices that have nonstop active routing configured on them.
CAUTION: Before attempting nonstop active routing switchover, check the
output of show bgp replication to confirm that BGP routing table
synchronization has completed on the backup Routing Engine. The complete
status in the output of show task replication only indicates that the socket
replication has completed and the BGP synchronization is in progress.
To determine whether BGP synchronization is complete, you must check the
Protocol state and Synchronization state fields in the output of show bgp
replication on the master Routing Engine. The Protocol state must be idle and
the Synchronization state must be complete. If you perform NSR switchover
before the BGP synchronization has completed, the BGP session might flap.
Options This command has no options.
Required Privilege
Level
view
Related
Documentation
show bgp replication logical-system•
List of Sample Output show bgp replication (for Master) on page 1830
show bgp replication (for Master) on page 1830
show bgp replication (for Backup) on page 1830
Output Fields Table 115 on page 1829 lists the output fields for the show bgp replication command. Output
fields are listed in the approximate order in which they appear.
Copyright © 2017, Juniper Networks, Inc.1828
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
