satop-options (Physical Interface)
Syntax satop-options {
excessive-packet-loss-rate {
sample-period milliseconds
threshold percentile
)
idle-pattern pattern
jitter-buffer-latency milliseconds
jitter-buffer-packets packets
payload-size bytes;
}
Hierarchy Level [edit interfaces interface-name]
Release Information Statement introduced in Junos OS Release 12.2 for the ACX Series Universal Access
routers.
Description Set Structure-Agnostic TDM over Packet (SAToP) protocol options.
Options excessive-packet-loss-rate options—Packet loss options.
• sample-period milliseconds—Number of milliseconds over which excessive packet loss
rate is calculated.
• threshold percentile—Percentile designating the threshold of excessive packet loss rate
(from 1 to 100).
idle-pattern pattern—An 8–bit hexadecimal pattern to replace TDM data in a lost packet
(from 0 to 255).
jitter-buffer-latency milliseconds—Number of milliseconds delay in jitter buffer (from 1 to
1000 milliseconds).
jitter-buffer-packets packets—Number of packets in jitter buffer (from 1 to 64).
payload-size bytes—Payload size in integer number of bytes.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring SAToP Emulation on Channelized T1 and E1 Interfaces on page 191
Copyright © 2017, Juniper Networks, Inc.1716
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
