show multicast snooping route
Syntax show multicast snooping route
<regexp>
<active>
<all>
<bridge-domain bridge-domain-name>
<brief >
<control>
<data>
<detail >
<extensive>
<group group>
<inactive>
<inet>
<inet6>
<instance instance-name>
<logical-system logical-system-name>
<mesh-group mesh-group-name>
<qualified-vlan vlan-id>
<source-prefix source-prefix>
<vlan vlan-id>
Release Information Command introduced in Junos OS Release 8.5.
Support for control, data, qualified-vlan and vlan options introduced in Junos OS Release
13.3 for EX Series switches.
Description Display the entries in the IP multicast snooping forwarding table. You can display some
of this information with the show route table inet.1 command.
Options none—Display standard information about all entries in the multicast snooping table for
all virtual switches and all bridge domains.
active | all | inactive —(Optional) Display all active entries, all entries, or all inactive
entries, respectively, in the multicast snooping table.
bridge-domain bridge-domain—(Optional) Display the entries for a particular bridge
domain.
brief | detail | extensive—(Optional) Display the specified level of output.
control—(Optional) Display control route entries.
data—(Optional) Display data route entries.
group group—(Optional) Display the entries for a particular group.
inet—(Optional) Display IPv4 information.
inet6—(Optional) Display IPv6 information.
instance instance-name—(Optional) Display the entries for a multicast instance.
2747Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
