Juniper ACX2000

CHAPTER 35
Configuring Virtual Private LAN Service
•
Introduction to VPLS on page 1235
•
Introduction to Configuring VPLS on page 1236
•
VPLS Multihoming Overview on page 1237
•
Configuring VPLS Routing Instances on page 1239
•
Configuring Interfaces for VPLS Routing in ACX Series on page 1255
•
Configuring VLAN Identifiers for VLANs and VPLS Routing Instances in ACX
Series on page 1262
•
Configuring Static Pseudowires for VPLS on page 1266
•
Configuring VPLS Without a Tunnel Services PIC on page 1267
•
Configuring VPLS Multihoming (FEC 128) on page 1268
•
Configuring Firewall Filters and Policers for VPLS in ACX Series on page 1271
•
Configuring Interoperability Between BGP Signaling and LDP Signaling in
VPLS on page 1274
•
Interoperability Between BGP Signaling and LDP Signaling in VPLS on page 1279
•
PE Router Mesh Groups for VPLS Routing Instances on page 1281
•
Example: Configuring BGP-Based H-VPLS Using Different Mesh Groups for Each Spoke
Router on page 1282
•
Example: Configuring LDP-Based H-VPLS Using a Single Mesh Group to Terminate
the Layer 2 Circuits on page 1304
•
Example: Configuring H-VPLS With VLANs on page 1310
Introduction to VPLS
VPLS is an Ethernet-based point-to-multipoint Layer 2 VPN. It allows you to connect
geographically dispersed Ethernet local area networks (LAN) sites to each other across
an MPLS backbone. For customers who implement VPLS, all sites appear to be in the
same Ethernet LAN even though traffic travels across the service provider's network.
NOTE: In ACX Series routers, VPLS configuration is supported only on
ACX5048 and ACX5096 routers.
1235Copyright © 2017, Juniper Networks, Inc.