CESoPSN Options
The following statements are supported at the [edit interfaces interface-name
cesopsn-options] hierarchy level:
•
excessive-packet-loss-rate (sample-period milliseconds)
•
idle-pattern pattern
•
jitter-buffer-latency milliseconds
•
jitter-buffer-packets packets
•
packetization-latency microseconds
show Commands
The show interfaces interface-name extensive command is supported for t1, e1, and at
interfaces.
CESoPSN Pseudowires
CESoPSN pseudowires are configured on the logical interface, not on the physical
interface. So the unit logical-unit-number statement must be included in the configuration
at the [edit interfaces interface-name] hierarchy level. When you include the unit
logical-unit-number statement, circuit cross-connect (CCC) for the logical interface is
created automatically.
Related
Documentation
Setting the CESoPSN Options on page 216•
SAToP Emulation on T1 and E1 Interfaces Overview
Structure-Agnostic time-division multiplexing (TDM) over Packet (SAToP), as defined
in RFC 4553, Structure-Agnostic TDM over Packet (SAToP) is supported on the ACX Series
Universal Access routers with built-in T1 and E1 interfaces. SAToP is used for pseudowire
encapsulation for TDM bits (T1, E1). The encapsulation disregards any structure imposed
on the T1 and E1 streams, in particular the structure imposed by standard TDM framing.
SAToP is used over packet-switched networks, where the provider edge (PE) routers do
not need to interpret TDM data or participate in the TDM signaling.
NOTE: ACX5048 and ACX5096 routers do not support SAToP.
Figure 14 on page 111 shows a packet-switched network (PSN) in which two PE routers
(PE1 and PE2) provide one or more pseudowires to customer edge (CE) routers (CE1 and
CE2), establishing a PSN tunnel to provide a data path for the pseudowire.
Copyright © 2017, Juniper Networks, Inc.110
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
