service-type (RFC2544 Benchmarking)
Syntax service-type (elan | eline) ;
Hierarchy Level [edit services rpm rfc2544-benchmarkingtests test-name test-name]
Release Information Statement introduced in Junos OS Release 12.3X53 for ACX Series routers.
Statement introduced in Junos OS Release 14.2 for MX104 3D Universal Edge routers.
Description Mention the service under test. Possible values are elan and eline. This statement is
applicable only for the bridge family or when the mode is configured as reflect. When the
service type is elan, MAC addresses are swapped by default on the reflected frames. The
no-mac-swap is not supported in this service type. When the service type is eline, MAC
addresses are not swapped by default in the reflected frames. Use the mac-swap option
to swap the addresses.
NOTE: When you configure the Layer 2 reflection, you can specify the service
type under test as ELINE if you want to simulate an ELINE service using bridge
encapsulation.
Options elan—Specify elan service type.
eline—Specify eline service type.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• rfc2544-benchmarking on page 1698
• Configuring an RFC 2544-Based Benchmarking Test
• RFC2544-Based Benchmarking Tests Overview
1715Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
