NOTE: You can assign multiple time slots on a CT1 interface. In the set
command, separate the time slots by commas and do not include spaces
between them. For example:
[edit interfaces ct1-1/0/0:1:1]
user@host# set partition 1 timeslots 1-4,9,22-24 interface-type ds
To verify this configuration, use the show command at the [edit interfaces ct1-1/0/0:1:1]
hierarchy level.
[edit interfaces ct1-1/0/0:1:1]
user@host# show
partition 1 timeslots 1-4 interface-type ds;
An NxDS0 interface can be configured from channelized T1 interface (ct1). Here N
represents the time slots on the CT1 interface.
The value of N is 1 through 24 when a DS0 interface is configured from a CT1 interface.
After you partition the DS interface, configure the CESoPSN options on it. See “Setting
the CESoPSN Options” on page 216.
Configuring CESoPSN on DS Interfaces
To configure CESoPSN encapsulation on a DS interface, include the encapsulation
statement at the [edit interfaces
ds-mpc-slot/mic-slot/port-number:channel:channel:channel] hierarchy level.
1. In configuration mode, go to the [edit interfaces
ds-mpc-slot/mic-slot/port-number:channel:channel:channel] hierarchy level.
[edit]
user@host# edit interfaces ds-mpc-slot/mic-slot/ port-number:channel:channel:channel
For example:
[edit]
user@host# edit interfaces ds-1/0/0:1:1:1
2. Configure CESoPSN as the encapsulation type and the logical interface for the DS
interface.
[edit interfaces ds-mpc-slot/mic-slot/port-number:channel:channel:channel]
user@host# set encapsulation cesopsn unit interface-unit-number
For example:
[edit interfaces ds-1/0/0:1:1:1 ]
user@host# set encapsulation cesopsn unit 0
To verify this configuration, use the show command at the [edit interfaces ds-1/0/0:1:1:1]
hierarchy level.
[edit interfaces ds-1/0/0:1:1:1]
Copyright © 2017, Juniper Networks, Inc.210
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
