show lacp interfaces
Syntax show lacp interfaces
<interface-name>
extensive
Release Information Command introduced in Junos OS Release 7.6.
extensive statement introduced in Junos OS Release 16.1R1
Description Display Link Aggregation Control Protocol (LACP) information about the specified
aggregated Ethernet, Fast Ethernet, or Gigabit Ethernet interface.
Options none—Display LACP information for all interfaces.
interface-name—(Optional) Display LACP information for the specified interface:
• Aggregated Ethernet—aenumber
• Fast Ethernet—fe-fpc/pic/port
• Gigabit Ethernet—ge-fpc/pic/port
• 10 Gigabit Ethernet—xe-fpc/pic/port
extensive—Display LACP information for the interface in detail.
NOTE: The show lacpinterfaces command returns the following error message
if your system is not configured in either active or passive LACP mode:
“Warning: lacp subsystem not running – not needed by configuration”
Required Privilege
Level
view
List of Sample Output show lacp interfaces (Aggregated Ethernet) on page 2724
show lacp interfaces (Gigabit Ethernet) on page 2724
show lacp interfaces (10 Gigabit Ethernet) on page 2725
Output Fields Table 166 on page 2721 lists the output fields for the show lacp interfaces command. Output
fields are listed in the approximate order in which they appear.
Table 166: show lacp interfaces Output Fields
Field DescriptionField Name
Aggregated interface value.Aggregated interface
2721Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
