Juniper ACX2000

• Example: VPLS Multihoming, Improved Convergence Time
Configuring VPLS Routing Instances
To configure a VPLS routing instance, include the vpls statement:
vpls {
active-interface {
any;
primary interface-name;
}
connectivity-type (ce | irb | permanent);
control-word;
encapsulation-type encapsulation-type;
interface-mac-limit limit;
import-labeled-routes [ routing-instance-name ];
label-block-size size;
mac-table-aging-time time;
mac-table-size size;
neighbor neighbor-id;
no-control-word;
no-tunnel-services;
site site-name {
active-interface {
any;
primary interface-name;
}
interface interface-name {
interface-mac-limit limit;
}
mesh-group mesh-group-name;
multi-homing;
site-identifier identifier;
site-preference preference-value {
backup;
primary;
}
}
site-range number;
traceoptions {
file filename <files number> <size size> <world-readable | no-world-readable>;
flag flag <flag-modifier> <disable>;
}
tunnel-services {
devices device-names;
primary primary-device-name;
}
vpls-id vpls-id;
}
You can include this statement at the following hierarchy levels:
•
[edit routing-instances routing-instance-name protocols]
1239Copyright © 2017, Juniper Networks, Inc.
Chapter 35: Configuring Virtual Private LAN Service