show dhcp relay binding
Syntax show dhcp relay binding
<address>
<brief>
<detail>
<interface interface-name>
<interfaces-vlan>
<interfaces-wildcard>
<ip-address | mac-address>
<logical-system logical-system-name>
<routing-instance routing-instance-name>
<summary>
Release Information Command introduced in Junos OS Release 8.3.
Options interface and mac-address added in Junos OS Release 8.4.
Options interfaces-vlan and interfaces-wildcard added in Junos OS Release 12.1.
Command introduced in Junos OS Release 12.1X48R3 for PTX Series Packet Transport
Routers.
Description Display the address bindings in the Dynamic Host Configuration Protocol (DHCP) client
table.
Options address—(Optional) Display DHCP binding information for a specific client identified by
one of the following entries:
• ip-address—The specified IP address.
• mac-address—The specified MAC address.
• session-id—The specified session ID.
brief—(Optional) Display brief information about the active client bindings. This is the
default, and produces the same output as show dhcp relay binding.
detail—(Optional) Display detailed client binding information.
interface interface-name—(Optional) Perform this operation on the specified interface.
You can optionally filter on VLAN ID and SVLAN ID.
interfaces-vlan—(Optional) Show the binding state information on the interface VLAN
ID and S-VLAN ID.
interfaces-wildcard—(Optional) The set of interfaces on which to show binding state
information. This option supports the use of the wildcard character (*).
logical-system logical-system-name—(Optional) Perform this operation on the specified
logical system.
routing-instance routing-instance-name—(Optional) Perform this operation on the
specified routing instance.
2455Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
