Juniper ACX2000

• Configuring the Drop Timeout Period on Multilink and Link Services Logical Interfaces
• Limiting Packet Payload Size on Multilink and Link Services Logical Interfaces
• Example: Configuring a Link Services Interface with MLPPP
• encapsulation (Logical Interface)
Configuring the Minimum Number of Active Links on Multilink and Link Services Logical
Interfaces
NOTE: Only MLPPP is supported on ACX Series routers. MLFR is not supported
on ACX Series routers.
You can set the minimum number of links that must be up for the multilink bundle as a
whole to be labeled up. By default, only one link must be up for the bundle to be labeled
up. A member link is considered up when the PPP Link Control Protocol (LCP) phase
transitions to open state.
The minimum-links value should be identical on both ends of the bundle.
To set the minimum number, include the minimum-links statement:
minimum-links number;
You can include this statement at the following hierarchy levels:
•
[edit interfaces interface-name unit logical-unit-number]
•
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
For link services interfaces, you also can configure the minimum number of links at the
physical interface level by including the minimum-links statement at the [edit interfaces
ls-fpc/pic/port:channel mlfr-uni-nni-bundle-options] hierarchy level:
minimum-links number;
The number can be from 1 through 8. The maximum number of links supported in a bundle
is 8. When 8 is specified, all configured links of a bundle must be up.
Related
Documentation
Link and Multilink Services Overview•
• Configuring Encapsulation for Multilink and Link Services Logical Interfaces on page 514
• Configuring the Drop Timeout Period on Multilink and Link Services Logical Interfaces
• Limiting Packet Payload Size on Multilink and Link Services Logical Interfaces
• Configuring MRRU on Multilink and Link Services Logical Interfaces on page 516
515Copyright © 2017, Juniper Networks, Inc.
Chapter 17: Configuring MLPPP