EasyManua.ls Logo

Juniper ACX2000

Juniper ACX2000
3270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service Filter Match Conditions for IPv4 Traffic on page 1038
Service Filter Actions on page 1039
CoS for NAT Services on ACX Series Universal Access Routers on page 887
Network Address Translation Constraints on ACX on page 1003
Configuring Address Pools for Network Address Port Translation (NAPT) Overview on
page 1007
Network Address Translation Rules Overview on page 1004
Configuring Service Sets for Network Address Translation on page 1030
Configuring Service Sets to Be Applied to Services Interfaces on page 1031
Configuring Queuing and Scheduling on Inline Services Interface on page 1040
Network Address Translation Constraints on ACX
You should consider the following constraints while configuring Network Address
Translation (NAT) on ACX Series routers:
When a port is defined in a NAT pool, you can configure only one address or one address
range in the pool.
ACX Series routers support nat-rules with match-direction as input. match-direction as
output is not supported.
When you specify an address range or an address prefix in a NAT pool, the maximum
number of addresses supported is 65,535. ACX Series routers supports up to 4096
network address translations at a time.
The maximum number of service sets that can be configured is 2.
In a NAT rule term, the from clause can contain a maximum of 4 matching addresses.
The maximum terms per NAT rule allowed is 4.
The maximum NAT rules per service set allowed is 2.
Related
Documentation
Network Address Translation Overview on page 999
Network Address Port Translation Overview on page 1001
Enabling Inline Services Interface on ACX Series on page 1008
Understanding Service Sets on page 1028
Guidelines for Applying Service Filters on page 1036
Network Address Translation Address Overload in ACX Series on page 1001
CoS for NAT Services on ACX Series Universal Access Routers on page 887
Configuring Address Pools for Network Address Port Translation (NAPT) Overview on
page 1007
1003Copyright © 2017, Juniper Networks, Inc.
Chapter 31: Configuring Network Address Translation (NAT) and Stateful Firewall Services

Table of Contents

Other manuals for Juniper ACX2000

Related product manuals