Related
Documentation
ACX Series Autoinstallation Overview on page 75•
• Before You Begin Autoinstallation on an ACX Series Universal Access Router on page 77
• Autoinstallation Configuration of ACX Series Universal Access Routers on page 78
• Verifying Autoinstallation on ACX Series Universal Access Routers on page 79
• USB Autoinstallation on ACX Series Routers on page 80
• Autoinstallation on ACX Series Routers in Hybrid Mode Overview on page 81
• Autoinstallation Process on a New ACX Series Router in Hybrid Mode on page 84
• Configuring Autoinstallation of ACX Series Routers in Hybrid Mode on page 87
• autoinstallation on page 1442
• show system autoinstallation status on page 3178
Autoinstallation Process on a New ACX Series Router in Hybrid Mode
You can perform autoinstallation on a new ACX Series router in hybrid mode, which is a
combination of the USB-based autoinstallation process and the network-based
autoinstallation process.
This configuration method has the following requirements:
•
A management device (PC or laptop).
•
An external USB storage device with one of the following 16-bit or 32-bit file allocation
table (FAT) file systems:
•
DOS 3.0+ 16-bit FAT (up to 32 MB)
•
DOS 3.31+ 16-bit FAT (over 32 MB)
•
FAT32
•
FAT32, LBA-mapped
•
16-bit FAT, LBA-mapped
BOOTP, RARP and DHCP are the supported protocols for acquisition of IP address of
the router and TFTP, FTP, and HTTP are the supported protocols for downloading the
configuration file from an external server URL on which the configuration file is stored.
The following operations occur during autoinstallation in hybrid mode on ACX Series
routers:
Copyright © 2017, Juniper Networks, Inc.84
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
