e2e-transparent
Syntax e2e-transparent;
Hierarchy Level [edit protocols ptp]
Release Information Statement introduced in Junos OS Release 14.1X53-D25 for the QFX Series.
Statement introduced in Junos OS Release 15.1X54-D20 for the ACX5048 and ACX5096
routers.
Description Configure the end-to-end (E2E) transparent clock for Precision Time Protocol (PTP).
With an end-to-end transparent clock, only the residence time is included in the timestamp
in the packet. Transparent clock functionality is supported on PTP over Ethernet, IPv4,
IPv6, unicast, and multicast. With PTP over Ethernet, one or two VLANs are supported.
Transparent clock functionality is enabled globally and might be required in scenarios in
which the interface on which packets are received and transmitted is unknown.
NOTE: ACX5048 and ACX5096 routers do not support PTP over IPv6 for
transparent clocks.
Options There are no options.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
• Configuring Transparent Clock Mode for Precision Time Protocol on page 269
1505Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
