Juniper ACX2000

show route protocol
List of Syntax Syntax on page 3093
Syntax (EX Series Switches) on page 3093
Syntax show route protocol protocol
<brief | detail | extensive | terse>
<logical-system (all | logical-system-name)>
Syntax (EX Series
Switches)
show route protocol protocol
<brief | detail | extensive | terse>
Release Information Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
ospf2 and ospf3 options introduced in Junos OS Release 9.2.
ospf2 and ospf3 options introduced in Junos OS Release 9.2 for EX Series switches.
flow option introduced in Junos OS Release 10.0.
flow option introduced in Junos OS Release 10.0 for EX Series switches.
Description Display the route entries in the routing table that were learned from a particular protocol.
Options brief | detail | extensive | terse—(Optional) Display the specified level of output. If you
do not specify a level of output, the system defaults to brief.
logical-system (all | logical-system-name)—(Optional) Perform this operation on all
logical systems or on a particular logical system.
protocol—Protocol from which the route was learned:
• access—Access route for use by DHCP application
• access-internal—Access-internal route for use by DHCP application
• aggregate—Locally generated aggregate route
• arp—Route learned through the Address Resolution Protocol
• atmvpn—Asynchronous Transfer Mode virtual private network
• bgp—Border Gateway Protocol
• ccc—Circuit cross-connect
• direct—Directly connected route
• dvmrp—Distance Vector Multicast Routing Protocol
• esis—End System-to-Intermediate System
• flow—Locally defined flow-specification route
• frr—Precomputed protection route or backup route used when a link goes down
• isis—Intermediate System-to-Intermediate System
3093Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands