Juniper ACX2000 Configuration Guide

maximum-sessions count;
maximum-sessions-per-connection count;
port udp-port-number;
server-inactivity-timeout minutes;
}
}
You can specify a number of TWAMP server properties, some of which are optional, by
including the server statement at the [edit services rpm twamp] hierarchy level:
[edit services rpm twamp]
server {
client-list list-name {
[ address address ];
}
authentication-mode mode;
maximum-connections count;
maximum-connections-per-client count;
maximum-sessions count;
maximum-sessions-per-connection count;
port udp-port-number;
}
•
To specify the list of allowed control client hosts that can connect to this server, include
the client-list statement at the [edit services rpm twamp server] hierarchy level. Each
value you include must be a Classless Interdomain Routing (CIDR) address (IP address
plus mask) that represents a network of allowed hosts. You can include multiple client
lists, each of which can contain a maximum of 64 entries. You must configure at least
one client address to enable TWAMP.
•
ACX Series routers do not support authentication and encryption modes. The value
for authentication-mode statement at the [edit services rpm twamp server] hierarchy
level must be set to none.
•
To specify the maximum number of concurrent connections the server can have to
client hosts, include the maximum-connections statement at the [edit services rpm
twamp server] hierarchy level. The allowed range of values is 1 through 2048 and the
default value is 64. You can also limit the number of connections the server can make
to a particular client host by including the maximum-connections-per-client statement.
ACX Series routers supports a maximum of 15 concurrent connections.
•
To specify the maximum number of sessions the server can have running at one time,
include the maximum-sessions statement at the [edit services rpm twamp server]
hierarchy level. The allowed range of values is 1 through 2048 and the default value is
64. You can also limit the number of sessions the server can have on a single connection
by including the maximum-sessions-per-connection statement. ACX Series routers
supports a maximum of 15 sessions.
•
To specify the TWAMP server listening port, include the port statement at the [edit
services rpm twamp server] hierarchy level. The range is 1 through 65,535. If a port range
is not specified, then the default port 862 is used.
•
TWAMP control connection traffic always arrives on ACX routers with the listening
port set as 862. Because this port number for traffic probes can be modified, probes
that arrive with a different port number are not recognized and processed by ACX
965Copyright © 2017, Juniper Networks, Inc.
Chapter 29: Understanding Network Management

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English