Juniper ACX2000 Configuration Guide

•
AE interface as a VRF interface (requesting multicast traffic) is not be supported.
•
Multicast traffic cannot be forwarded from the logical interface in a VRF domain if the
first hop router is an ACX router.
Related
Documentation
Understanding PoE on ACX Series Universal Access Routers
Power over Ethernet (PoE) is the implementation of the IEEE 802.3af and IEEE 802.3at
standards that allows both data and electrical power to pass over a copper Ethernet
LAN cable.
Juniper Networks provides PoE on ACX2000 Universal Access Routers that allows power
delivery up to 65 W per PoE port. PoE ports transfer electrical power and data to remote
devices over standard twisted-pair cables in an Ethernet network. Using the PoE ports,
you can plug in devices that require both network connectivity and electrical power, such
as voice over IP (VoIP) and wireless LAN access points.
You can configure the ACX2000 Universal Access Router to act as a power sourcing
equipment (PSE), supplying power to powered devices that are connected on designated
ports.
This topic contains the following sections: :
•
ACX2000 PoE Specifications on page 142
•
PoE Classes and Power Ratings on page 143
•
PoE Options on page 143
ACX2000 PoE Specifications
Table 19 on page 142 lists the PoE specifications for the ACX2000 routers.
Table 19: PoE Specifications for the ACX2000 Routers
For ACX2000 Universal Access RoutersSpecifications
•
IEEE 802.3 AF
•
IEEE 802.3 AT (PoE+)
•
Legacy (pre-standards)
Supported standards
Supported on only two Gigabit Ethernet ports (ge-0/1/3
and ge-0/1/7).
Supported ports
130 WTotal PoE power sourcing capacity
32 WDefault per port power limit
65 WMaximum per port power limit
Copyright © 2017, Juniper Networks, Inc.142
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English