Juniper ACX2000

rfc2544-benchmarking
Syntax rfc2544-benchmarking {
profiles {
test-profile profile-name {
test-type (throughput | latency | frame-loss | back-back-frames);
packet-size bytes;
step-percent percent;
bandwidth-kbps kpbs;
}
}
tests{
test-name test-name {
test-interface interface-name;
mode reflect;
family (bridge| inet | ccc);
destination-ipv4-address address;
destination-udp-port port-number;
source-ipv4-address address;
source-udp-port port-number;
direction (egress | ingress);
}
}
}
Hierarchy Level [edit services rpm]
Release Information Statement introduced in Junos OS Release 12.3X52 for ACX Series routers.
Statement introduced in Junos OS Release 13.3 for MX104 3D Universal Edge routers.
Description Configure the parameters for the RFC 2544-based benchmarking test. You must configure
a test profile, which specifies the type of test and the manner in which it must be
performed, and associate the test profile with a test name. The test name that you
configure contains details, such as the address family and the test mode, for the test.
You can associate the same test profile with multiple test names.
Define the attributes for the RFC 2544-based benchmarking test to examine and analyze
the performance characteristics of a network interconnecting device.
The remaining statements are explained separately. See CLI Explorer.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring an RFC 2544-Based Benchmarking Test
• RFC2544-Based Benchmarking Tests Overview
• show services rpm rfc2544-benchmarking on page 3156
• show services rpm rfc2544-benchmarking test-id on page 3161
Copyright © 2017, Juniper Networks, Inc.1698
ACX Series Universal Access Router Configuration Guide