Table 91: jnxSoamLmCfgTable (continued)
DescriptionObject IDObject
Clears the Loss Measurement history Table
(jnxSoamLmHistoryStatsTable) - all rows are deleted.
When read the value always returns 'false'. Writing this
value does not change the current stat table, nor any of
the items in the configuration table. Writing this value
during row creation has no effect.
JnxSoamLmCfgEntry
23
jnxSoamLmCfgHistoryClear
Specifies the status of the row. The writable columns in
a row cannot be changed if the row is active, except for
jnxSoamLmCfgHistoryClear and jnxSoamLmCfgEnabled
objects. All columns must have a valid value before a row
can be activated.
JnxSoamLmCfgEntry
24
jnxSoamLmCfgRowStatus
Managed Objects for jnxSoamLmMeasuredStatsTable
The jnxSoamLmMeasuredStatsTable, whose object identifier is {jnxSoamPmLmObjects
2}, contains the jnxSoamLmMeasuredStatsEntry that signifies the Ethernet loss
measurement (ETH-LM) statistical details. Each jnxSoamLmMeasuredStatsEntry, whose
object identifier is {jnxSoamLmMeasuredStatsTable 1}, contains the objects listed in the
following table.
The jnxSoamLmMeasuredStatsTable contains the last measured results for a SOAM Loss
Measurement session. Each row in the table represents a Loss Measurement session for
the defined MEP. This table uses four indices. The first three indices are the indices of
the Maintenance Domain, MaNet, and MEP tables. The fourth index is the specific LM
session on the selected MEP. Instances of this managed object are created automatically
by the SNMP Agent when the Loss Measurement session is running. Each object in this
table applies only if the corresponding bit is set in jnxSoamLmCfgMeasurementEnable.
The objects in this table do not need to be persistent upon reboot or restart of a device.
Table 92: jnxSoamLmMeasuredStatsTable
DescriptionObject IDObject
Contains the last frame loss ratio in the forward
direction calculated by this MEP. The FLR value
is a ratio that is expressed as a percent with a
value of 0 (ratio 0.00) through 100000 (ratio
1.00). Units are in milli-percent, where 1 indicates
0.001 percent.
jnxSoamLmMeasuredStatsEntry
1
jnxSoamLmMeasuredStatsForwardFlr
Contains the last frame loss ratio in the backward
direction calculated by this MEP. The FLR value
is a ratio that is expressed as a percent with a
value of 0 (ratio 0.00) through 100000 (ratio
1.00). Units are in milli-percent, where 1 indicates
0.001 percent.
jnxSoamLmMeasuredStatsEntry
2
jnxSoamLmMeasuredStatsBackwardFlr
Copyright © 2017, Juniper Networks, Inc.1184
ACX Series Universal Access Router Configuration Guide