Disabling PIM for a Rendezvous Point
You can disable the PIM protocol for a rendezvous point (RP) on a per-family basis. This
is accomplished at the [edit protocols pim rp local family] hierarchy level:
[edit protocols]
pim {
rp {
local {
family inet {
disable;
}
family inet6 {
disable;
}
}
}
}
To disable PIM for an RP family:
1. Use the disable statement.
user@host# set protocols pim rp local family inet disable
user@host# set protocols pim rp local family inet6 disable
2. (Optional) Verify your configuration settings before committing them by using the
show protocols pim command.
user@host# run show protocols pim
Copyright © 2017, Juniper Networks, Inc.690
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
