[edit chassis alarm relay output port port-number (input-relay | mode | temperature)]
For example, to set off the alarm when the system temperature goes into the red
status:
[edit chassis alarm relay output port 0]
user@host# set temperature
3. Verify the configuration with the show command:
[edit chassis alarm relay output port 0]
user@host# show
temperature;
4. Commit the configuration with the commit command.
To view the alarm output relay information, issue the show chassis alarms or show chassis
craft-interface command from the Junos OS command line interface.
Related
Documentation
User-Defined Alarm Relay Overview on page 158•
• input on page 1566
• show chassis craft-interface on page 1865
• show chassis alarms on page 1845
Chassis Definitions for Router Model MIB for ACX Series Routers
The enterprise-specific Chassis Definitions for Router Model MIB contain the OIDs that
are used by the Chassis MIB to identify platform and chassis components. The Chassis
Definitions for Router Model MIB provide information that changes less often.
The last number in each sysObjectId, shown in Table 27 on page 162, corresponds to the
router model and therefore does not change. This table displays the different ACX router
model numbers, their jnxProductName object names, and the associated sysObjectId
values.
Table 27: Router Models and Their sysObjectIds for ACX Series Routers
jnxProductNameSysObjectIDModel
jnxProductNameACX10001.3.6.1.4.1.2636.1.1.1.1.113ACX1000
jnxProductNameACX20001.3.6.1.4.1.2636.1.1.1.1.114ACX2000
jnxProductNameACX11001.3.6.1.4.1.2636.1.1.1.1.115ACX1100
jnxProductNameACX21001.3.6.1.4.1.2636.1.1.1.1.116ACX2100
jnxProductNameACX22001.3.6.1.4.1.2636.1.1.1.1.117ACX2200
Copyright © 2017, Juniper Networks, Inc.162
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
